Why use software with an encoder? The answer: to get the most from your motion system.
Mercury™ II encoders come complete with SmartPrecision II Software. Mercury II's pushbutton setup does not require use of the software, however this software adds unique functionality. Use it to do the following:
- Monitor system operation using digital readouts and data plots such as Lissajous
- Monitor motion system operation remotely from your office during system development and alpha testing
- Perform remote system support and diagnostics - engineering can support customers when the engineers are not in the same building or in the same country as the customer's motion system. Engineering can also support manufacturing or field service when teams are not in the same location
- Get diagnostic support from MicroE Systems no matter where your equipment is located
- Use programmable features for rapid integration and motion system optimization
Program Mercury II Encoder Electronics
- Set interpolation in integer steps from x4 to x16,384 (Mercury II 4800)
- Set maximum output frequency to match your controller
- Set limit output logic when necessary to match your controller's requirements
Install Mercury II Encoder Systems
- Align sensor using Signal Level display and Encoder Signal data plot
- Setup index limit markers and see when sensor is over the scale's index mark
- Verify sensor output over length of scale using the Signal Strength plot
Monitor Mercury II Encoder Operation
- Read encoder position in engineering units of your choice
- Read the encoder's hour meter to monitor system usage
- Capture alarms while system operates unattended
Diagnose Mercury II Encoder Performance
- Capture signal data and email it to MicroE for rapid diagnostic support
- Monitor alarms, view the alarm history log
